I'll test with a "regular" telephone line.
The manual for the paging amp says it has a 600-ohm balanced, transformer-isolated input for paging.
I have never done paging before, I am a tech, and I have never done this type of installation before, in fact I'm just testing this setup, which was recommended to me as a simple overhead paging system using existing equipment.
It's our office PA, currently working with a line out of the Panasonic PBX connected to ring and tip on the Bogen. I'm disconnecting it, and trying to page through our speakers from another PBX, using either a SNOM PA1 or an HT502.
Incidentally, I have cut up a 3.5mm stereo audio cable and used that to connect the Line Out of the SNOM PA1 to the tip and ring on the Bogen, and can page successfully (honestly, I didn't expect that to work).
Last edited by Joshua Lokken; 05/29/13 06:25 PM.
