So I have an update on what I’ve done so far
After basically double tapping the output from the Algo, 8301 using the AUX OUT
Sending one pair of wires to the TOA amplifier (input 7) and the other pair of wires is going to the Valcom audio pair
The paging sounded fine. However, when they played music through it, it was all cut up on the outside speakers.
So I spoke with Valcom and they recommend using the 70 V adapter and tapping off the output of the amplifiers (speaker wire)
That seem to make a big difference
However, they are complaining that in one of the buildings cuts out only when the late bell ring
I talked to Valcom and he recommended instead instead of using the AUX OUT on the Algo 8301 to use the LINE OUT and connected to input one on the amplifier
I’m gonna be heading over there today to see what I can
Some of the bells work fine it’s just that one particular late bell. I guess they call it.
Does anybody have any information on the Algo 8301
From what Valcom was saying that the line out needs to be set for 600 ohms and then going into input one on the TOA amplifier.
