atcomsystems.ca/forum Forums TDM Business Telephone Systems Mitel Telephones & Systems sx200 analog message lights

i have a sx200 gen 217 with a repartee mail
the ipc 217 had to be replaced and the system was reprogrammed
the message lights will not light on the sets
the repartee uses the superset ports for intergration
where in programming do i set the message lights on and off codes

If you are using COV integration then you should not need to set "codes" per se - the Repartee if set for Mitel COV should do the correct thing. Make sure that message waiting lamp in Room COS and you have to have the LAST port on the VMS in a separate hunt group on its own in order for it to light and turn of MW

thanks
but the message lamps in COS are enabled and the last vms port is not in the hunt group

Are you using analog or COV ports into the VM?

Last VMS port needs to be IN a hunt group. A SEPARATE hunt group - all on its little ol' lonesome

thanks
i will put the last vm port in its own hunt group

Let us know how it works - if it works