web statisticsweb stats

Business Phone Systems

Previous Thread
Next Thread
Print Thread
Rate Thread
Page 1 of 2 1 2
Joined: Sep 2007
Posts: 13
Member
OP Offline
Member
Joined: Sep 2007
Posts: 13
Good morning ~

We are using the MOH/Paging module as part of our Mitel 2000SX Light system to provide paging.

We have 100+ buildings that could potentially need speakers (1 for most, 2 for some) and hope to use newly installed phone pair to take the signal from two different demarc points to the various buildings.

Can anyone recommend a particular amp/speaker setup for this? Any advice would be most welcome!

Thanks,
Jeff

Atcom VoIP Phones
VoIP Demo

Best VoIP Phones Canada


Visit Atcom to get started with your new business VoIP phone system ASAP
Turn up is quick, painless, and can often be done same day.
Let us show you how to do VoIP right, resulting in crystal clear call quality and easy-to-use features that make everyone happy!
Proudly serving Canada from coast to coast.

Joined: Feb 2005
Posts: 12,344
Likes: 3
Member
***
Offline
Member
***
Joined: Feb 2005
Posts: 12,344
Likes: 3
Wow, 100 plus buildings. That's rather an ambitious project.

I'm not sure I would recommend audio over twisted pair for that extensive a system. What distances are we talking about?

Hate to say it but this might be a good application for an IP based distribution to each building. How is your networking between these buildings handled?

-Hal


CALIFORNIA PROPOSITION 65 WARNING: Some comments made by me are known to the State of California to cause irreversible brain damage and serious mental disorders leading to confinement.
Joined: Sep 2007
Posts: 13
Member
OP Offline
Member
Joined: Sep 2007
Posts: 13
Some up to 2000 feet.

The only available connections between buildings in the phone wiring. We have brand new pairs to each building so that's a plus.

Jeff

Joined: May 2007
Posts: 5,058
Likes: 5
Moderator-1A2, Cabling
*****
Offline
Moderator-1A2, Cabling
*****
Joined: May 2007
Posts: 5,058
Likes: 5
I'm not a big believer in powered speaker systems, but with only 1 or 2 speakers per building it might be just the thing.

Something by Valcom maybe. For the long runs you might have to double up the pairs.

Is this an "all call" configuration or do they want this zoned?

Sam


"Where are we going and why are we in this hand basket?"
Joined: Feb 2005
Posts: 12,344
Likes: 3
Member
***
Offline
Member
***
Joined: Feb 2005
Posts: 12,344
Likes: 3
Some up to 2000 feet.

What's the longest combined distance from the beginning to end? I assume that some if not all buildinge will be bridged off this run?

-Hal


CALIFORNIA PROPOSITION 65 WARNING: Some comments made by me are known to the State of California to cause irreversible brain damage and serious mental disorders leading to confinement.
Joined: Sep 2007
Posts: 13
Member
OP Offline
Member
Joined: Sep 2007
Posts: 13
This will be an "all zone" system that is only used for the most severe of emergencies.

We have two nodes and I was thinking of having the amplifiers in each node. The buildings home run back to their respective node so that is where the distance comes in.

Jeff

Joined: Feb 2005
Posts: 12,344
Likes: 3
Member
***
Offline
Member
***
Joined: Feb 2005
Posts: 12,344
Likes: 3
So you are saying that the 2000 ft run is from the farthest node to the PBX location?

Also, what does your wiring consist of? You say it is brand new, what kind of cable?

-Hal


CALIFORNIA PROPOSITION 65 WARNING: Some comments made by me are known to the State of California to cause irreversible brain damage and serious mental disorders leading to confinement.
Joined: Sep 2007
Posts: 13
Member
OP Offline
Member
Joined: Sep 2007
Posts: 13
Right. Everything home runs from the building back to the node. Pair 1 in Node 1 corresponds to Pair 1 in Building 1.

It's Cat3 phone wire to all homes.

Jeff

Joined: Feb 2005
Posts: 12,344
Likes: 3
Member
***
Offline
Member
***
Joined: Feb 2005
Posts: 12,344
Likes: 3
Well, I think you may have put the cart before the horse by installing wiring then trying to figure out what to do with it. You probably could have saved a bundle on wiring.

You may want to look at Valcom Encompass. I believe it's an IP based system with amplified Valcom speakers, it is what you are looking to do. Give them a call.

-Hal


CALIFORNIA PROPOSITION 65 WARNING: Some comments made by me are known to the State of California to cause irreversible brain damage and serious mental disorders leading to confinement.
Joined: Sep 2007
Posts: 13
Member
OP Offline
Member
Joined: Sep 2007
Posts: 13
The wiring actually had to be installed - old wire was in bad, bad shape.

Using extra pair for the paging system is add-on to something already in-place.

jg

Page 1 of 2 1 2

Moderated by  metelcom 

Link Copied to Clipboard
Forum Statistics
Forums84
Topics94,298
Posts638,868
Members49,769
Most Online5,661
May 23rd, 2018
Popular Topics(Views)
212,691 Shoretel
189,709 CTX100 install
187,894 1a2 system
Newest Members
Soulece, Robbks, A2A Networks, James D., Nadisale
49,768 Registered Users
Top Posters(30 Days)
Toner 26
teleco 9
dans 6
dexman 4
Who's Online Now
1 members (KRRath), 138 guests, and 303 robots.
Key: Admin, Global Mod, Mod
Contact Us | Sponsored by Atcom: One of the best VoIP Phone Canada Suppliers for your business telephone system!| Terms of Service

Sundance Communications is not affiliated with any of the above manufacturers. Sundance Phone System Forums - VOIP & Cloud Phone Help
©Copyright Sundance Communications 1998-2024
Powered by UBB.threads™ PHP Forum Software 7.7.5