From what I have read, these two do not work well with each other :confused: .
My boss handed me a phone asking me to try to get it up and running. I managed to get it to talk to the Firebox, but it does not connect. It hangs when it tries to check the network connectivity.
Can anyone walk me through the set up? I am new to voip and avaya so I really don't know what I am doing here :rolleyes: .
It is a
Server: 173.xx.xx.xxx
Username: voip
Password:xxxx
groupname: xauth
group psk: xxxx
VPN Start Mode: Boot
Password type: Save in Flash
Encapsulation 4500-4500
Syslog Server: Blank
IKE Parameters
USER-FQDN - DH1 - Any - Any
xchg mode - agressive
config mode - enabled
xauth - enable
cert expirycheck - disable
cert DN check - disable
IPSec Parameters:
DH1 - Any - Any (AES-256 - SHA1 also work as the settings in IPSec)
Protected nets
Virtual IP: 172.xx.xx.xx (not sure if this is right)
Remote Net#1: 172.xx.xx.x/xx (when I added this, the Firebox logs no longer showed unhandled external packets from the phone)
Copy TOS: No (what is this for?)
File Svr: Blank (important?)
Connectivity Check: Always
QTest: Disable
On a side note, disabling the connectivity check takes me to a screen that says
HTTPS:1 https//192.xxx.xxx.xxx/80 vpnupdate.scr
then it goes to a screen
that says
HTTP: 905?
Then to TFTP:4 192.xxx.xxx.xxx
* to program
Do I need some software to work the phone?
I've been checking the firebox, it says phase 1 completed, starts phase two but it stops after it receives the third message? Then it restarts
It also shows up on the authentication list, but I cannot ping to it.