Hello,

I have a CTX-670 that's connected to a paging system over a loop start trunk. Dial 44 to pickup the OLG associated with the paging trunk and then dial another 4 to signal the paging system to use all zones.

It was working fine until the CTX firmware and processor were upgraded to the latest version.

Now when you dial 444 to page, the 44 picks up the paging trunk and then the PBX delays almost 2 seconds before sending the last 4, to signal the zone. No one waits for the delay, causing the first two seconds of the page to be unheard.

Is there a way to disable the 1.5 - 2 second delay?

Thanks,

Barry