Quote
Originally posted by KLD:
Walter, "Frogging" goes back to "leap-frogging" cable pairs to make a line work. (White-Blue pair bad, cut to Violet-Slate from pole 1 to pole 2, cut back to White-Blue)

Now then, topic , Al, the suggestions here are all good. Do you have a test jack to test the output of the card at the backboard? Does it work there? Make a test jumper to plug into the station card with only this port wired out to the jack. Does it work? By then a spare card should be available, try it. Until you know if the problem is software or hardware you are not going to be able to follow this through. By testing the hardware you are left with software if the sets do not ring. That is where the ring group, et al, comes in. Go to a correctly ringing set, do a "Copy" and see if it is ringing now.

Good luck.
Geez, what a dope I am. I erred in my programming. The problem is that I used 3112 to terminate day and night ring on 4 of the 6 lines coming into the system to specific extensions (DILs). the other two lines terminated to a ring group with three extensions assigned to the group (600) and each assigned a message center key. I resolved it my 2121-01 06 CCK-R. Problem solved. I was not thorough in my troubleshooting. I will be more careful in the future.

Thanks for all of your help.

Al Dukes :db:

"Let Everything Be Done Decently and In Order" 1 Corinthians 14:40