Hello all,

I'm new to this thing and I'm having problem troubleshooting an installation.

Here's the setup:

Incomming line from Bell Canada's demarc to a front plug of an IBDN qcbix1a. In the back is the GW\WG pair going to a wall jack. GW\WG pair is connected to the wall jack using the red and green wire of a RJ11.

This setup works correctly (it's the internet connection, Bell's aDSL. )

Right next to the GW\WG connection in the bix is a BW\WB connection, which is wired to the wall-jack right next to the previous one, and the BW\WB is connected to the wall jack in the same fashion. This is the fax wall jack.

The fax just doesn't work. I know that I should have a connection between the GW\WG and BW\WB pair to make it work. When I punch a pair between the to connector's at the punch-down block, it doesn't work.

How should I wire those to make it work.

Thanks in advance.



------------------
David 'NetShaman'

David 'NetShaman'