I know some of you might need this on an ESI system when installing a Polycom to an analog station port so here it is. I had to get some help from ESI TS after searching the net.

1. Press and hold mute
2. Power cycle Polycom while holding mute
3. Release mute after "BONG" is heard
4. Press and release #
5. Press and release *
6. Enter the code below depending on how many ms you need

200 = 100ms
100 = 300ms
000 = 600ms

For Premier the above is the same. However during coding, add an "0" infront. Example 0200 = 100ms on the Premier.

You should now be able to create a conference from the Polycom by using the flash, flash, dial, flash sequence.


-MO