|
|
Joined: Feb 2010
Posts: 496 Likes: 1
Member
|
OP
Member
Joined: Feb 2010
Posts: 496 Likes: 1 |
I was doing some prep work on a Install at the customer site just programming everything up .Had to change my numbering plan from 100's to 200's got the voice mail working programmed all the cap keys PRI everything seemed to be fine then I wanted to go upstairs and start programming from the customer's network so I plugged in the cable from there old Aspire system and put in the correct IP Address
Once I got connected to the system upstairs I notice that not all but most of the programming was defaulted I don't think I have ever seen the default on an NEC system before I did have to power the system down at one point to mount it on the wall it was probably off for about 30 minuets or so the only programming that stayed was the PRI Programming and when I went to program 47-01-17 I could put a 2 digit port number in there I originally had 57 which worked fine but could not put any number in there except for a 3 digit number
Any thoughts
JD
|
|
|
Visit Atcom to get started with your new business VoIP phone system ASAP
Turn up is quick, painless, and can often be done same day.
Let us show you how to do VoIP right, resulting in crystal clear call quality and easy-to-use features that make everyone happy!
Proudly serving Canada from coast to coast.
|
|
Forums84
Topics94,284
Posts638,769
Members49,765
|
Most Online5,661 May 23rd, 2018
|
|
0 members (),
152
guests, and
298
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
|
|