Ok, so this is encouraging!!

However, what needs to be known here is are there any specific program
changes that are needed to make the Conference call on a Non-NEC
Single Line Phone to function as desired??

Or will it work out of the box??

Also, I have found now two(2) SLT User Guides that say two(2) different things
on the page with instructions about Conference Calls.

Issue 1.0
May 2017
Press HookFlash followed by #1


Issue 1.0
September 2017
Press HookFlash followed by 8 - 2 - 6

I can only "ass'u'me" that the September version may/might be correct.

My concern is as above any program changes that would be needed.

Also these keystrokes seem to be for the actual SLT phone from NEC.

Will this also apply to any Non-NEC analog conference phone that is connected to this SL2100 SLT Port??

Where I don't want to is the get a unit only to find out later I should have purchased this other
unit because the first was not compatible.

Again, any hints or suggestions would be most helpful.

Thanks,

Les

Last edited by ABLE1; 11/16/20 05:27 PM.