sundance-communications.com/forum Forums TDM Business Telephone Systems Mitel Telephones & Systems 200ICP

Went to install a t1 module and stratum3 clock module.Powered down the system installed parts turned back on and system would not boot up.Took parts back out turned on system and came up ok.

A few minutes later a guy told me he couldn't call out so I start checking and come to find out I put my buttset on the lines and tried to dial out.I would hit 8 then the number then there would be about a ten second pause the you could hear one digit then another ten seconds you would hear the next then get the telco intercept call cannot be comp[leted as dialed.

They use the vmail for auto att so when you call in it rings a few times then dead silence so I tried to dial an ext and zero but nothing would happen.I tried to dail the hunt access and it does the same thing it will pick up but then nothing happens.

I am thinking the dsp got fried fromt the t1 install but not sure any suggestions.


Thanks

Les

Forgot to add.I put co line keys on phones and directly acces them and there is a little delay before you get dialtone but can dial out and recieve calls.

I'm guessing this is a floppy driven digital or light? Otherwise, why would you be installing a stratum 3 clock card. Isn't the clock part of the MCC from the factory on 200ICP?
Check seating of, and then DTMF card(s) on, the universal card(s).

Mingo,

Which version of 200ICP and model are you using?

Most units come with a S3 card on the motherboard. Make sure yours does not have one and if not make sure you put the S3 on the right connector.

No the mx 200icp doesn't come with a t1 clock card. I would try a different dsp.

Yes it is an mx so it does need the stratum 3 module.

Thanks john p that's what I was thinking.

Bad DSP.Replaced it now works fine.