sundance-communications.com/forum Forums Other TDM Phone Systems Nitsuko-Tie Telephones & Systems Nitsuko 384i - Networking

Can Nitsuko 384i network multiple systems?

The short answer to your question is yes it can. Over point to point t-1 circuits. I believe you can network up to 5 systems together as the system can only support 5 t-1 cards. However, they may have updated it to support more, they were supposed to, but I'm not sure they ever implemented it.

Thanks. So do you feel IP Networking is not a capability on the 384i?

You can definetly network 384i's togeather, and it will work very well. You will need t-1 circuits in place to do it. I've done 4 or 5 of them so far with the biggest customer having 3 sites. It works great if it is set up properly. As far as doing it via IP, I dont think you can link individual systems, but you can do VOIP using thier gateway unit and have system phones connected off premise at the remote site.

[This message has been edited by smddoc (edited July 16, 2004).]

Thanks. Can you tell me more about this VOIP Gateway. Does it support Centuralized voice mail, IP Phone sets, Centuralized attendant?

There is a Networking manual available from NEC Prt# 92000LAN07. The remote Gateway/Extenders are designed to extend NEC phones across WANS not to Network remote systems and they are very, very pricey. You could almost install a complete remote system and network it for the same money.

Thanks for the info and good advise.