|
|
Joined: Jun 2004
Posts: 100
Member
|
OP
Member
Joined: Jun 2004
Posts: 100 |
I have an existing cust. with a T1 for outgoing and DID(Norstar MICS 4.1). They want to upgrade the existing T to PRI. I understand that I have to purchase 'PRI enabler' and install the keycodes.
Can someone send me instructions on what I need to program in the Norstar after I input the keycodes? Also, does this have to be cut in conjunction with the carrier and how much downtime on the circuit?
|
|
|
|
|
Joined: Oct 2002
Posts: 279
Member
|
|
Member
Joined: Oct 2002
Posts: 279 |
It's not that big of a deal, you just enter the keycodes in programming under "Software Keys", then change your card to PRI under "Hardware". You will need to know line coding info and protocol type from the telco. As for the down time the customer experiences, depends on how quickly you get this done and telco. If my memory serves me right, you also have to go to lines 1-23 and configure for E&M Winkstart.
|
|
|
|
|
Joined: May 2003
Posts: 2,924
Member
|
|
Member
Joined: May 2003
Posts: 2,924 |
You should upgrade to 6.1mr also. Some issues with PRI on 4.1. Also change dial route from pool a to pri. Did will be target lines.
|
|
|
|
|
Joined: Jun 2004
Posts: 100
Member
|
|
OP
Member
Joined: Jun 2004
Posts: 100 |
Is it necessary to upgrade to 6.1?
What are the issues? Appreciatte your input.
|
|
|
|
|
Joined: Oct 2002
Posts: 279
Member
|
|
Member
Joined: Oct 2002
Posts: 279 |
There are issues with 5.0, not so sure about 4.1 at least I don't seem to remember any.
|
|
|
|
Forums84
Topics93,879
Posts637,000
Members49,673
| |
Most Online5,661
May 23rd, 2018
|
|
|
1 members (Toner),
24
guests, and
22
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
|
