ICS with T1

Print Thread

Rate Thread

ICS with T1 #125091 09/21/05 07:51 AM
Joined: Mar 2005 Posts: 19 Olympia mjamm Member
mjamm Member Joined: Mar 2005 Posts: 19 Olympia	I have a Norstar ICS with a T1 card tied back to my Option 81C PBX with a Point to Point circuit with (8BZF/ESF). The norstar will default calls to our console on the PBX in mid-conversations. Error come up on the T1 in the PBX and the Norstar shows Alarm 44-0 with numberous event codes indicating an issue with T1. I work on the larger systems and am not that familiar with the Norstar. How should the lines be configured in the Norstar in this configuration? Currently they are set for E&M. Thanks in advance!

Nortel Phone System Service

Nortel Phone System Service in Canada

Do you need a Nortel Phone System technician or specific Nortel parts?
Atcom to the rescue! Our telephone techs have qualified experience servicing and troubleshooting Nortel CICS, MICS, & BCM telephone systems.
Service in Canada from sea to sea.

Re: ICS with T1 #125092 09/21/05 08:14 AM
Joined: Aug 2004 Posts: 9,172 Likes: 22 SOUTH TEXAS RATHER BE FISHING Admin
RATHER BE FISHING Admin Joined: Aug 2004 Posts: 9,172 Likes: 22 SOUTH TEXAS	You could have several issues. E&M wink is correct for tie line apps. I would LD 60 in the 81 and run an count of the issues on the T1 from the 81 side. Look for bipolars,slips,frame loss,etc. This could point to either a hardware/programming trouble on either side or a clocking issue. ------------------ Business Phone Systems

Moderated by MooreTel

Hop To

Link Copied to Clipboard

sundance-communications.com/forum Forums TDM Business Telephone Systems Nortel Telephones & Systems ICS with T1