|
|
|
|
Joined: Nov 2005
Posts: 4
Member
|
|
Member
Joined: Nov 2005
Posts: 4 |
Hi There - my company is using a fairly old KSU (8x24 with 3-0x16 modules) which was recently upgraded to DR5.1 to allow installation of a Flash VM unit (our StarTalk finally died).
Sadly, I know very little about phone systems, even though I am now its administrator. I've got tons of issues, but right now I'm concerned about the paging.
The previous software (DR3 or so) produced a two-part tone before a page. It wasn't great, but it was fine. The new software seems to be giving us a single note, more abrasive tone, which I'm sure I'm about to get a memo on. The manual for the DR5.1 system says that one of the new features is the ability to turn the page tone off. But I can't seem to find a way to do that. I've logged into System Programming, but the menu item that I expect to find (and is mentioned elsewhere on this board) isn't there. Any help would be appreciated.
|
|
|
Nortel Phone System Service in Canada
Do you need a Nortel Phone System technician or specific Nortel parts?
Atcom to the rescue! Our telephone techs have qualified experience servicing and troubleshooting Nortel CICS, MICS, & BCM telephone systems.
Service in Canada from sea to sea.
|
|
|
|
Joined: Oct 2005
Posts: 4,685 Likes: 4
Member
|
|
Member
Joined: Oct 2005
Posts: 4,685 Likes: 4 |
It is located in
configuration > system programming
Marv CCNA, CTUB
TeleMarv Services (Retired)
Providing telecommunication solutions in Ottawa Canada since 1990
|
|
|
|
|
Joined: Nov 2005
Posts: 4
Member
|
|
Member
Joined: Nov 2005
Posts: 4 |
Thanks Marv - I didn't know about the Config menu, but our service provider got back to me with the info (finally).
|
|
|
|
Forums84
Topics94,541
Posts640,062
Members49,854
| |
Most Online5,661
May 23rd, 2018
|
|
|
|
|
|
