|
|
Joined: Aug 2006
Posts: 82
Member
|
OP
Member
Joined: Aug 2006
Posts: 82 |
I am installing a mics 7.0 software, 32 channel pri. This is my first time programming from scratch. I have all the programming done for the sets but I need I need to complete the programming for the PRI/target lines. As an installer I need help with want I should be programming for the PRI. Any help would be so appreciated. Thanking you all in advance.
|
|
|
Nortel Phone System Service in Canada
Do you need a Nortel Phone System technician or specific Nortel parts?
Atcom to the rescue! Our telephone techs have qualified experience servicing and troubleshooting Nortel CICS, MICS, & BCM telephone systems.
Service in Canada from sea to sea.
|
|
|
|
Joined: Feb 2007
Posts: 2,473
Member
|
|
Member
Joined: Feb 2007
Posts: 2,473 |
No problems LT.
Tell as what you need! Target lines starts from 157. You have to program digits and prime ext. number for that Target line and assign that line to Appr & Ring at the right extension. That is all.
|
|
|
|
|
Joined: Aug 2006
Posts: 82
Member
|
|
OP
Member
Joined: Aug 2006
Posts: 82 |
thanks vad60 I was not sure what the Target lines started at. Programming the target lines i've done. I am pre prgramming this offsite. I have entered the enabler keycodes for the PRI, I have prgrammed each of the extensions in terminal and sets. I need to know if there is any special programming required for the PRI other than the Target Lines and once I install and before I call the Telco to make sure they can see the PRI is there anything I should do as far as programming. I tried finding the info in a book but not to successful.
|
|
|
|
|
Joined: Jun 2005
Posts: 2,256
Member
|
|
Member
Joined: Jun 2005
Posts: 2,256 |
Have you set up the Protocol? You will also need to set up routes.
|
|
|
|
|
Joined: Feb 2007
Posts: 2,473
Member
|
|
Member
Joined: Feb 2007
Posts: 2,473 |
Richard is right.
In Hardware Option you have to setup your Protokol to match the Provider's settings. You have to go to Services for Routing and assign Route to use your PRI and Enable all exts to use that PRI-A or B or whatever Pool you've desided. You have to assign Primary clock for your PRI's Network sinchronization.
|
|
|
|
|
Joined: Feb 2006
Posts: 598
Member
|
|
Member
Joined: Feb 2006
Posts: 598 |
L T, if you need a hand let me know, as I have set up a thousand of these and am in town.
Mike
Two girls later and I'm back.....lol...been gone a while but see same faces still here. Lol
|
|
|
|
|
Joined: Aug 2006
Posts: 82
Member
|
|
OP
Member
Joined: Aug 2006
Posts: 82 |
Thanks guys I will give this a try, I'll be back if I have problems
Thanks to everyone.
|
|
|
|
Forums84
Topics94,297
Posts638,867
Members49,769
| |
Most Online5,661
May 23rd, 2018
|
|
|
1 members (justbill),
165
guests, and
282
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
|
