sundance-communications.com/forum Forums TDM Business Telephone Systems Nortel Telephones & Systems BCM 50

I have a BCM 50 system installed and for some reason the page output has gone dead. Has anyone experienced this and is there a fix out there .

Have you verified its a port issue?
You should be able to use a volt/ohm meter to verify contact closure.

I am not using the page contact closure. I am using the page out tip/ring

Hook up your butt-set to it and try. If nothing go to Maint. and take a look on port status. If it busy Disable it and after update finishes Enable it again.

Could you please tell me in Maint. where I would find the page out port to see if it is disabled or not. I don't recall Thank you

CUDJOE: I have no idea where in Maint you would find what vad60 is saying about disable. :shrug: :shrug:

To properly test go through this check list.
A) Connected to pair 12 on main unit amphenol (Black/Orange)
B) Use butt set to monitor (disconnect other wires)
C) Using F62 to send page and talking through handset.
D) When you use F62, do you hear a Click from the main unit right after you push the 2 .
......You should hear a click from the relay even if you aren't using it.

If you still get nothing then you may have a bad port. Not aware of any easy fix other than replace the unit.

I appologize. I thought you are using port(tip/ring).