|
|
|
|
Joined: Jun 2004
Posts: 100
Member
|
|
Member
Joined: Jun 2004
Posts: 100 |
Apparently this alarm started happening every 30 minutes or so and customer cannot receive calls until they clear it from x221. I went on site looked in Maintenance in telset programming and it has happened 136 times in the log! Any ideas? To make matters worse when I tried to access the OAM port with my laptop the default username and password would not work. When I installed it I did all my programming from the phone as the codes were all loaded.
|
|
|
Nortel Phone System Service in Canada
Do you need a Nortel Phone System technician or specific Nortel parts?
Atcom to the rescue! Our telephone techs have qualified experience servicing and troubleshooting Nortel CICS, MICS, & BCM telephone systems.
Service in Canada from sea to sea.
|
|
|
|
Joined: Dec 2003
Posts: 2,086
Former Moderator-Nortel
|
|
Former Moderator-Nortel
Joined: Dec 2003
Posts: 2,086 |
If I found the right list, it says your system is over heating. Are your fans working? Is the room too hot? Does it need cleaned out - too much dirt covering components ? Need to blow a BIG fan on the system ?
If CON is the opposite of PRO
Then what is the opposite of Progress?
|
|
|
|
|
Joined: Jun 2004
Posts: 100
Member
|
|
Member
Joined: Jun 2004
Posts: 100 |
Room is not too hot - in a basement. Sounds like my first step should be to open it up. Is their one fan and is it obvious? Any ideas on my other dilemna about the OAM port password.
|
|
|
|
|
Joined: Dec 2003
Posts: 2,086
Former Moderator-Nortel
|
|
Former Moderator-Nortel
Joined: Dec 2003
Posts: 2,086 |
OEM port - What is the software version?
There are two lights on the front of the BCM-50.
Are they red or green?
If older software, if red light, you probably will not connect. VM may not work either.
New software, Does VM work? Yes, Not sure why it won't connect. Sure your Caps Lock wasn't on? Did you change the password and forgot?
If CON is the opposite of PRO
Then what is the opposite of Progress?
|
|
|
|
|
Joined: Jun 2004
Posts: 100
Member
|
|
Member
Joined: Jun 2004
Posts: 100 |
Release 2 software. One LED red and one green. VM works fine and checked it with Caps and without. I never did access this BCM thru an ethernet connection so password not changed; only Telset programming. Its a small system with 6 phones. Is the Alrm 11406 a patch issue? How do you reset password on OAM port?
|
|
|
|
Forums84
Topics94,518
Posts639,976
Members49,850
| |
Most Online5,661
May 23rd, 2018
|
|
|
2 members (justbill, KRRath),
301
guests, and
49
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
|
|
|
