|
|
|
|
Joined: Feb 2006
Posts: 598
Member
|
|
Member
Joined: Feb 2006
Posts: 598 |
Called out to a site cp down. Installed replacement cp, couldn't get either to come back. Ports tested fine and worked. Turns out the site contact was in config programming and never ended. We checked any active sets found it. Released the programming and bang system came up. Anyone else ever heard of being in programming on a mics not allowing the cp to fully go online?
Two girls later and I'm back.....lol...been gone a while but see same faces still here. Lol
|
|
|
Nortel Phone System Service in Canada
Do you need a Nortel Phone System technician or specific Nortel parts?
Atcom to the rescue! Our telephone techs have qualified experience servicing and troubleshooting Nortel CICS, MICS, & BCM telephone systems.
Service in Canada from sea to sea.
|
|
|
|
Joined: Nov 2003
Posts: 1,310
Member
|
|
Member
Joined: Nov 2003
Posts: 1,310 |
Can't recall that specific situation, but I have had to re-boot both systems simultaneously on occasion to get them to talk.
D. Ocean
Miami, FL
|
|
|
|
|
Joined: Oct 2005
Posts: 4,685 Likes: 4
Member
|
|
Member
Joined: Oct 2005
Posts: 4,685 Likes: 4 |
Never had that happen, but then again i never tried booting a CP with a set in programming mode. I know you can only have one set in that mode. A second set will give you an error if you try to enter programming mode.
Marv CCNA, CTUB
TeleMarv Services (Retired)
Providing telecommunication solutions in Ottawa Canada since 1990
|
|
|
|
Forums84
Topics94,515
Posts639,952
Members49,847
| |
Most Online5,661
May 23rd, 2018
|
|
|
1 members (justbill),
272
guests, and
45
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
|
|
|
