|
|
Joined: Dec 2004
Posts: 10
Member
|
OP
Member
Joined: Dec 2004
Posts: 10 |
Terminal downloads of system reports work fine for me on a TVS50, but the TVS200 requires ANSI emulation and, having tried many ways, still now success. Repeated error message from the TVS200 to the "GPRN" command is, "ANSI required."
I have tried two emulation programs, used various tactics like, set ANSI emulation/save/close/reopen; disconnect/reconnect, etc. Still get the same "ANSI required" error message.
A veteran no doubt would know about this!
Thanks, guys.
mwm
|
|
|
|
|
Joined: Dec 2004
Posts: 10
Member
|
|
OP
Member
Joined: Dec 2004
Posts: 10 |
typo -- above post should say, " ... NO success."
mwm
|
|
|
|
|
Joined: Oct 2001
Posts: 4,043
Member
|
|
Member
Joined: Oct 2001
Posts: 4,043 |
I really don't know what your trying to do but I can tell you I never had a problem using the exact same laptop with the same settings and same cable to communicate with any of the TVS units. 50,75, 80, 90, 100, 120, 125, 200, 225
and so on.
Hyper-Term, 9600-8 N and 1. no flow control and a NULL modem cable.
Did you try resetting ONLY the Comm. parameters on the 200?
Set the rotary switch to position 1 and reboot.
Gem
|
|
|
|
|
Joined: Apr 2005
Posts: 26
Member
|
|
Member
Joined: Apr 2005
Posts: 26 |
are you using a full 9 pin to 25 pin cable or are you using a cat 5 cable with rj45 to serial adpt's. for downloads you must have a full 9 pin to 25 pin cable.
|
|
|
|
|
Joined: May 2004
Posts: 324
Member
|
|
Member
Joined: May 2004
Posts: 324 |
25 pin connector 9 pin connector
here are the cable pinouts
25pin..........9 pin
pin 1 unused pin 1unused
pin 2 goes to pin 2
pin 3 goes to pin 3
pin 4 goes to pin 8
pin 5 goes to pin 7
pin 6 goes to pin 4
pin 7 goes to pin 5
pin 20 goes to pin 6
|
|
|
|
Forums84
Topics93,879
Posts637,000
Members49,673
| |
Most Online5,661
May 23rd, 2018
|
|
|
1 members (mitel_icp_tech),
39
guests, and
16
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
|
