atcomsystems.ca/forum Forums Other TDM Phone Systems Telrad Telephones & Systems ONS External Ringer Cable connections

We have a system that we are trying to install, but the external ringer power cable was removed on both ends and we have not instructions on how it connects to the ringer. Is there any diagrahm showing the wiring and where each wire goes?

The system is a Telrad Key BX system and the ringer is a Advance F20112 and the ONS card is a 76-110-2700.

Thanks

I don't know witch ringer you got. I don't know part numbers but the ring genrator goes on pretty easy. One plugs into the card like a power cable for a hard drive in the front of the card (it's plastic and white) and mounts on the outside of the 400 cabinet (so if you don't have a 400 cabinet just mount it to the wall) this unit is black with a green led light on it. The other just screws on to the card itself and the power goes through the screws you used to mount it on the card(this unit is black and has some wieght to it).

[This message has been edited by tony3866 (edited February 21, 2005).]

The problem is that the cable is no longer attached to the black box (Ringer) so I have 4 wires but no idea where or in what order to connect them back to the black box, the plastic end is pretty straight forward.

Thanks

Time to get the Volt meter out and do some testing.
You may not need the ring gen at all if you have a ONS2

------------------
ssimpson@oneringtelecom.com Need a Telrad Programmer Kit? Telrad Programmer Kits

I have it out ready to go, just thought I'd ask first to save some time.

Thanks

I'll look at one in my office tommorow.