|
Joined: Aug 2004
Posts: 11
Member
|
OP
Member
Joined: Aug 2004
Posts: 11 |
Hello, I've got an 8-line executive display phone (EX2) plugged into an ELD card on a Telrad Digital 400 version 7.34. We use PRI (but I doubt that would be a factor here). It is the only phone on bus #8 and the only phone complaining of this problem. I'm having a symptom where sometimes when the speaker phone is activated (either by using the hot dialpad, or recieving an internal call) I will get a second or two of hard static, and then the phone will reset. This (of course) does not happen every single time, but I have seen it happen myself. I do not get an "out of sync" or an "init error" and outside of dropping that call, the phone will generally continue to operate just fine afterwards. I've replaced just about everything that is practical to replace: the phone itself, the line cord, the wiring on my 66 blocks, and I've even swapped the phone to a port on another ELD. The problem will seam to go away for a few days, and then come back. I'm running out of things to blame (I always have myself, but that isn't doing me much good at the moment). Any ideas?
Thanks a lot.
|
|
|
Visit Atcom to get started with your new business VoIP phone system ASAP
Turn up is quick, painless, and can often be done same day.
Let us show you how to do VoIP right, resulting in crystal clear call quality and easy-to-use features that make everyone happy!
Proudly serving Canada from coast to coast.
|
|
|
Joined: Mar 2001
Posts: 7,350
RIP Admin
|
RIP Admin
Joined: Mar 2001
Posts: 7,350 |
It sounds like a short in the cable, looks like you have replaced everything but the station cable. I would replace it and see if that doesn't clear it up.
Russ runs a local service and private tech center. [/url]
|
|
|
|
Joined: Aug 2004
Posts: 11
Member
|
OP
Member
Joined: Aug 2004
Posts: 11 |
Yeah - I was getting towards that same conclusion. I was Just holding out some last hope that there would be something left to try that I could do myself :p
Cabling - especially in a building this size - is something I try to stay out of.
Thanks for the reply.
|
|
|
|
Joined: Aug 2002
Posts: 4,928 Likes: 1
Administrator
|
Administrator
Joined: Aug 2002
Posts: 4,928 Likes: 1 |
How about just switching data pairs. Move the cross connect to green pair and change the jack.
|
|
|
|
Joined: Mar 2001
Posts: 7,350
RIP Admin
|
RIP Admin
Joined: Mar 2001
Posts: 7,350 |
Yes you can try the other pairs and see if it works. I would usualy just run a new cable and jack then your sure you've covered it.
Russ runs a local service and private tech center. [/url]
|
|
|
Forums84
Topics94,317
Posts638,933
Members49,775
|
Most Online5,661 May 23rd, 2018
|
|
0 members (),
171
guests, and
55
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
|