sundance-communications.com/forum Forums TDM Business Telephone Systems Toshiba Telephones & Systems ivp8 setup on ctx100

im trying to find some documentation on setting up the ivp8 card i have it in slot 8 ..

programmed as a Rstu BSTU or Ivp8 - 8 standard ports

i used to have an external analog (connected vai the rdsu) card strategy dialogic....

but now im just trying to configure the ivp8 do i point the card in station assignment to the new 010801 or am i missing a step

thanks


OHH and im normally a mitel Guy hehe im using eman right now to connect to the system and try to convert the old vm to the new ....

my ext numbers are 300,301,302,303




thanks again

Slot 8 is right.....RSTU/BSTU/IVP8
Station assignments....Stations 300-303 set as VoiceMail ports, 300 is 010801, 301 is 010802 and so on.

Create your Hunt Group, then in Station Assignments, fb15 is your HG pilot number.

That's the basics.

i believe i just figured it out i just changed the port assignments from 010201 to 010801 and it seemed to take it to the new card since it was programmed before ....

And there ya go.............

ohhh thanks i posted the last one not realizing i got a response i think in the system they had an external stragey card and my hunt group is 555 but it forward to the hunt group

i just have to figure out if i did the Pri right it was a 16port card but i took out the 010301 and removed it and put the 24 port and assigned 23 b channels....

but other then those forms im not sure if i had to look anywhere else

i saw maintenance it had an error but im assuming because it wasnt syncd up

thanks

That should be all you have to do. I always assign it as a 24 channel card and only enable the proper number of 'B' channels. That way, if I have to increase from 16 channels to 23, all I have to do is enable the additional 'B' channels.

Now just rebuild the channel group.

Just like when I add a BDKU I assign it as a 16 port card.

THe only problem I run into when installing it as a 24 channel pri is that all B channels are enabled at first, so I can't even program the PRI unless I have enough licenses for all 23 channels.

I've come across that too. I learned to set up the PRI Channel Group and B channels before I do anything else. That was a hard lesson.........