sundance-communications.com/forum Forums TDM Business Telephone Systems Vodavi Telephones & Systems page port

Can anyone tell me were the page port is on a vodavi gdk-100 psu-3. I can move phones and the like but have no manuals are real experience with this phone system. thanks.

emmitt:
I think the GDK series is known also as the Vodavi Infinite---Mach 1, II or III--depending on the size of KSU. Assumming that you have no page module on this system, You will have to purchase a Relay/Sensor Interface module for external paging. Click on the EQUIPMENT link on this site. You may also want to click on the MANUALS link too if you are going to do any programming on this system. External paging will require a 3-digit paging code, so you may want to put a PAGE key on every phone. Good Luck

How would I know the page module? Is it a card that slides into the cabinet. There is a 25 pair connecter that has a pair label for music on hold. Is it on the same card? If so, what pins?

EM:
The Relay/Sensor Interface Module is a box-like unit that has, on the working end, 3 Relay terminals on the left, a modular jack (RJ-11) in the middle, and 3 Sensor terminals on the right. The middle jack is usually hooked up to a surface jack by a line cord. The surface jack is then terminated to a digital port on the 66M station block. The terminals are hooked up to whatever it is you are hooking up. It may be mounted on the wall, with the working end to the side, or maybe some other way--it all depends on the installation setup and where space is on the wall. It may be sitting on the cabinet. If you have one, it will be hooked up to your paging amplifier, and the amplifier will be hooked up to your speakers. There are however, other ways to hook up a paging system--possibly using Paging Adapters (from Wheelock or Viking) hooked up to a line port and using that programmed line key to access the paging system. Good Luck

emmitt, if this really is a MACH I, external paging t/r should be on the yellow/slate pair, just above the moh pair. you will have to dial a 3 digit code to access paging. not sure what that is at the moment, but will look it up and let you know.
depending upon the software version the page code should be either 760 or 761. go off hook on a system phone and dial the code, you should hear the page warning tone, by default the page warning tone is enabled.


[This message has been edited by dosjock (edited January 01, 2005).]

I got a little more info on this thing. It is a tr 8003-00 model with triad phones. I have been told it is discontinued. there is a dtib240 card, a icob card, a prib card, a misb card, and a mpib card

The MISU card on the Triad 1 BKSU-8003-00 is the BGM, MOH & Page card. The tip & ring of the page port is on the bkgn/gnbk pair (pins 38 & 13) on the 66 block. All call (int & ext) code is 70 while just the external page is 76+0 or 76+1 as dosjock has indicated.
The DTIB is a 24 port digital station board, PRIB is a Primary Rate Interface-ISDN card, LCOB is a Loop Start CO card and the MPB is the Main Processor. Good Luck.

THANKS FOR THE HELP, I FOUND THE PAGING PORT THAT THEY WERE ACCESSING 2 PAIRS DOWN FROM WHERE YOU SUGGESTED, I WOULDN'T HAVE KNOWN WHERE TO LOOK WITH OUT THE HELP THANKS AGAIN
EMMITT2727

Hi, the psu 3 is just the power supply, if you want to add a page port you will need a MISB (red handles on the card)