Business Phone Systems

Previous Thread
Next Thread
Print Thread
Rate Thread
Joined: Jun 2004
Posts: 20
Member
OP Offline
Member
Joined: Jun 2004
Posts: 20
Hello All,

Was wondering if there was anyway to block outgoing caller ID on the 2400? Been searching through the manuals and the caller ID seems to always been in regards to the analog lines. I also tried to use the *67 like I use at home, but no luck.

I did find a spec sheet that says its possible, but no specifics on how to do it.

Any help would be greatly appreciated.

TIA,
Tom

Atcom VoIP Demo
VoIP Demo
Joined: May 2004
Posts: 22
Member
Offline
Member
Joined: May 2004
Posts: 22
You can block call id on PRI circuits
If look in ASFC SFI 94 turns on or off ANI on outbound not sure what software rev you have so older revs may not work
Also ACND and ACNP work if yuo want to change what is sent over a PRI.

If the circuits are not PRIS then you would have to call the carrier to see if they can change the displayed number.

Joined: Jun 2004
Posts: 20
Member
OP Offline
Member
Joined: Jun 2004
Posts: 20
Thanks for the pointers NECTECH.
Much Appreciation


Moderated by  ttech 

Link Copied to Clipboard
Forum Statistics
Forums84
Topics93,883
Posts637,024
Members49,675
Most Online5,661
May 23rd, 2018
Popular Topics(Views)
Today's Birthdays
Adam Randall, Felton 1967, FeltonD, paezacero, Spencer
Newest Members
tech3500, APInc, m1cashman, jonnycom, XJR9000
49,674 Registered Users
Top Posters(30 Days)
Toner 11
jsaad 8
teleco 6
dexman 5
Shahza 4
Who's Online Now
0 members (), 59 guests, and 15 robots.
Key: Admin, Global Mod, Mod
Contact Us | Sponsored by Atcom: Business Phone Systems | Terms of Service

Sundance Communications is not affiliated with any of the above manufacturers.
©Copyright Sundance Communications 1998-2023
Powered by UBB.threads™ PHP Forum Software 7.7.5