atcomsystems.ca/forum Forums TDM Business Telephone Systems NEC Telephones & Systems NEC Dterm80 Headset..

Can I get those instructions as well Rickman? Thanks in advance!

Rickman,
Please forward the instructions to me also for the Nec dterm 80 on an Electra Elite IPK. Thanks in advance.

Hello Rickman,

I sure hope you are still around. Is there any chance you could please assist me as well?

DTerm 80 16 button phone, trying to program the Headset button.

Thank you in advance one way or the other!
-Casey

Okay, I just joined this forum because it's the only place where I believe I can get help with the same question, but a slight tweak, that's been asked and answered several times.

I followed the instructions that bbox, who, obviously walks on water, provided. Now, a different issue. When using my headset I can hear the person on the other end just fine, but nobody on the other line can hear me. I hit 751+ a blank key + 05 + speaker. Lo and behold, I now just hit that no longer blank key and hear the dialtone through my headset! But since then I can make calls through the headset but even though I can hear the person on the other line that person can't hear me.

I thought it might be the headset so I tried two more. Same problem. I then hooked all three headsets to my old phone, and all worked fine. I could hear fine and so could the other person. I can't go back to my old phone because in order for the receptionist located upstairs to answer my phone, I have to use this type of phone, which must be the type that makes all that work. The phone is an NEC Dterm80.

It may or may not be relevant but I have noticed that while I'm speaking through my headset, when I turn the volume up and down the display that shows the volume going up and down reads "handset." Please, brilliant people, help me! I had fusion in my neck, but it didn't help my neck pain a whole lot. It just hurts like hell to talk on the phone even for a few minutes without without using a headset! Please, help! Thanks so much for everything y'all have already don for me. It's saved me countless hours of useless googling.

Hello. I'm having the same issue here. The model is a NEC DTERM 80 (DTH-16D-1) and we are trying to setup the headset, the extra funtion keys shows as "unused" and feature is selected. Any suggestions? Thanks a bunch in advance...

Hi, I need your help in guiding me to configure a headset button on a NEC Dterm80 8 button system. I currently have one free button to assign as the headset button. We are on Elite IPK2. Thanks a lot!

If Rickman or anyone else who he has PM'd with this info is still available...

I too have a Dterm 80 8-button with a couple of buttons free. We have an Elite IPK1.

I hope there's help out there. Thank you in advance for any assistance you can offer

I have a similar problem and need to reprogram voice mail and by pass ex employee's passwords and I don't have a Manuel Please help me

I've programmed the headset button i needed but I've also reprogrammed our main line (Line 1) on two of the ports, (Port1 & 2) unknowingly. Could anyoen perhaps help me reprogram these two button to be able to pick up our main incoming calls. When i Feature 4 on the main line it reads VACANT, when I feature 4 on the Line 2 it reads "C LINE 2" or something I can't read all the letters. I appreciate any help you can provide.

Just hoping someone is still moderating this...

We have an Electra Elite IPK phone system and would like to set it up so we can use a headset on our Dterm80 phone.

Thanks for any help, information, and guidance.