|
|
Joined: Jul 2003
Posts: 114
Member
|
Member
Joined: Jul 2003
Posts: 114 |
I am lost...I can't find any directions on an analoge cordless.
NEC 2000 IPS. Operator = Ext.200. DTR-16D-1 just added an AP(R) with Power. Tried APr in BOTH Slots.
Operator also is a CSR rep, 5 CSR lines Ring her and all other CSR Reps. She has X200 and X300 (virtual)
I get dial tone on Cordless, dTerm screen reads 200 when cordless goes offhook. dTerm rings normal, Cordless won't ring or come alive. IF I come offhook when dTerm rings...the Cordless DOES get the call.
She wants to walk around (mail, copy etc.) and take the Cordless with her. What programming is needed for the cordless? Can it be it's own Ext #? What "codes" do single lines use for features? Can she get the CSR lines and her X200 to all ring? (I guess she wouldn't know which is which?) Sadly I will admit I didn't check the Ringer on the Cordless with a CO....system has a T1...I can. will., should have. I did swap out the AC adapter with a known good one.
I read about Settings on the APr: 1-1 1-2 3-1 3-2 I ONLY saw one slide switch in the side, labled "1-2 1-2" Space for two switches but only one under the first 1-2. ?? changing that one switch didn't seem to matter.
There is a set of 8 dip switches. one aned 5 were ON. I didn't mess with them. Where is 3-1? I think 1-2 is the only one I need......"Share B channel" What does that do? either way?
COMMANDS: 1205 - 0 1308 - ? 9001 - 1 9003 - 1 1332 forget, I have in my notes "correct"
ANY Suggestions? More importantly, will / Should a cordless work in the manner they want? Mobile Operator?
I use an older Elite 192 manual, seems about 99% applicable.
|
|
|
Visit Atcom to get started with your new business VoIP phone system ASAP
Turn up is quick, painless, and can often be done same day.
Let us show you how to do VoIP right, resulting in crystal clear call quality and easy-to-use features that make everyone happy!
Proudly serving Canada from coast to coast.
|
|
|
Joined: Sep 2008
Posts: 63
Member
|
Member
Joined: Sep 2008
Posts: 63 |
1332=0, 1333=1, 1335=1, I think is all you need. A system restart is required.
All-Tronics Inc. Battle Creek Michigan 1-800-968-7171
|
|
|
|
Joined: Jul 2003
Posts: 114
Member
|
Member
Joined: Jul 2003
Posts: 114 |
HAHAHAHAAHAHAHAHAH OW!!! In the end it was...... wait for it Tone/Voice Ring (V/T) Seems obvious, huh? Well as I tested Incoming rings to this operators phone...it always rings! When I finally tried and stumbled upon V/T while testing intercom ring....it worked. Obviously circuitry in the ph's amplifier and whatever signal is sent down includes a ring bit when ring is set. That cleared it up! 601
|
|
|
Forums84
Topics94,512
Posts639,934
Members49,844
|
Most Online5,661 May 23rd, 2018
|
|
|
|
|