sundance-communications.com/forum Forums Computers & Programming Computers, Software, Accessories DirecWay/Hughes.Net

This may be better off in the Networking Forum but we'll try here first.

I have a client who is using the old DirecWay (now Hughes) 2-Way satellite system. This system is one that has the two boxes stacked for the modem and brings the connection in on a USB cable. Then for networking purposes, ICS is enabled and the connection feeds out via a patch cable to a switch.

No other broadband is available for their area. The current speeds being obtained are 790 Kbps down, and 375 Kbps up.

The client has expressed an interest in upgrading the hardware to the new modems that bring in an RJ45 handoff and bypass the USB issue. I am told this will increase the speed and reliability.

Does anyone have experience with this?

Thanks.

It will definitely improve reliability, probably speed also, and they won't have to leave that computer on for the others to get internet. Just plug the modem into a router (Linksys, Netgear, Cisco...) and the router into the switch.

Joe:

Have you actually worked on one of these, and if so did you do the converstion/upgrade?

What is the distance between the points? We have been installing some Cisco stuff for one of our customers and it seems to work very good and pretty fast.

I worked with one of the older ones like you're talking about and it was a pain to set up with ICS. With the new equipment, the modem plugs into the router and you configure the router for whatever type of login or ip the satellite requires. Most routers handle static ip, DHCP, PPPoE login, and a few other types, one of those should work with the satellite.

I haven't converted a satellite from USB to ethernet, but I've done that with cable modems several times. Hopefully the modem will come pre-configured or with setup information. If you have any problems getting it set up, give me a call.

Zane, I'm not quite sure what you're asking. I'm sure I just need another cup of coffee but could you clairfy? Thanks.

Joe, thanks for the input. As for the conversion, it'll be no problem. I was just wondering if anyone had done a converstion to see a real life example of how much better it will work afterwards. After all, we'll still be using the original dish etc.

One other question. Did you get a good speed test on the new modem? Thanks again.

Sorry for the delay, got caught up in other stuff.

Going from USB to ethernet did get a very slight speed increase, but also made it much more reliable.

Thanks. I'll pass it along to the client.

I have switched these out. There is no noticeable increase in speed. Additionally the dish must be replaced on the rooftop for the newer Ethernet connection specific modem (at least that’s what dtv made the customer buy) The only advantage to moving over is the ease of connecting additional PC’s, and being able to use standard routers and wireless AP’s on the network. Although the modem provided by dtv is a router and nats with no problems on multiple connections.

We actually did see some appreciable speed changes on this particular change over. Perhaps it was just the bird that we were on originally but just in case anyone is interested, here are the new numbers:

Old System: 790 Kbps down, and 375 Kbps up.

New System: 1.5Mbps down, and 600+ Kbps up.
(I didn't remember the exact upload speed)

Thanks for the input guys.