sundance-communications.com/forum Forums Computers & Programming Computers, Software, Accessories Replacing Old Dumb Terminal

I'm working on replacing an old dumb terminal that is used for AS400 emulation. The terminal has a PSC RF-1000 scanner connected in series with the keyboard. All the old machine is used for is scanning material bar codes that are entered into the AS400. Nothing more, nothing less.

This is the old unit:
https://www.ioconnections.com/productdetail.aspx?id=71

This is the my new replacement thin client:
https://h18000.www1.hp.com/products/quickspecs/13148_ca/13148_ca.PDF

This HP unit uses this emulator:
https://h20000.www2.hp.com/bizsuppo...odTypeId=18964&objectID=c01514306#A1

Everything works great as far as key mapping and AS400 emulation. The problem I'm having is when I scan a bar code it recognizes the scan and then continues to enter repeating 1's or 2's.

Example:
A good scan will give this result- WR10347726
The result I'm getting on the HP Thin client is - WR1031111111111111111111111111111 or WR1032222222222222222222222222222
and the emulator will continue entering the 1's or 2's unit I escape out. Then I have to reset the emulation. :shrug:

Forgive my long explanation. Any thoughts?

Seems like your connected fine but the scanner itself is not setup correctly. Found a nice pdf for the scanner that will help you test and configure.
Otherwise I would contact them for assistance.

https://www.posguys.com/download/PSCPowerScanRFManual.pdf

Thanks for your help with this.

I have a copy and have read the manual you posted. As far as programming adjustments for the scanner. I'm not seeing anything in it that stands out to correct this issue.

So your thinking the issue is the scanner and not the emulator? I was leaning towards the emulator only because the emulator/thin client is the new piece of this puzzle. The scanner was existing and working with the old terminal. I am an admitted rookie at this type of setup though.

I will re-visit the manual. Thanks!