sundance-communications.com Forums Computer Internet Computers, Software, Accessories Access Point Question

This is my second Cisco AP1142n install. The first one installed perfectly. I"m working on the second install.
The IP has been assigned via DHCP and I know the IP address of the unit. I used the MAC address to verify.

1. I cannot connect to it using the web GUI. From what I have read the image out of the box must be WLAPP and I need it to be Autonamous. Is this correct?
2. Also apparently you have to be a BP to get the Autonamous IOS image. Is this correct?

Thanks!

I have installed Cisco PA's but were were controlled by Cisco AP controllers. Have you tried some of the Cisco forums to get a response to this question?

I also found the configuration guide. Take a look and see if it has the answer for you.

https://www.cisco.com/en/US/docs/wi...A1/configuration/guide/scg12421aJA1.html

My hunch was correct. The AP had the wrong IOS image. I returned it for an autonamous AP.

Thanks!