sundance-communications.com/forum Forums Other TDM Phone Systems VoiceMail Systems and Programming Bravo 1, No User Serviceable Parts Inside

I think I no the answer: trash.

But this Forum is TOPS....so I'll ask.

Client (a church) has a Bravo 1 dying. Behind a Samsung DCS.
1st indication was the Pastors greeting changed to a "motor boating" sound. Thought it had been "recorded" so I had hime re-record....all fine.

As I was leaving I placed some calls in to test. I noticed that when 2 calls came in at the same time, one got kicked out - disconnected.
Almost like Tip or Ring was shorted to second line, ring trips.

Turn off Bravo....OK
Moved CO's & ports...still bad
Changed VM ext's & ports...still bad

When you are connected to Bravo, main greeting
and a second call comes in, existing call is dropped. Sometimes the 2nd call does get answered after kicking the 1st call out, sometimes not.

Pastors problem I thought was corrupted memory.
May have been caused by a CO short while someone
was leaving a message. Hardware peoblem.

Anyone repair these? A capacitor inside?

Right now I suggested they have a human answer during the day. Very low traffic. But I went ahead and only programmed 1 VM ext, but now if someone doesn't dial out of VM (long main greeting) calls will have to ring a long time.

anyone repair these?
I doubt it's economically feasible.

Did the Bravo One use a dongle for ports 3 & 4?

Thanks People.

Long time since i used a bravo 1 on a samsung
found the best way to clear is to default the bravo and reprogram dont use the back you downloaded unless you have the oringinal one