sundance-communications.com Forums Telephony Discussion Phone & VoIP Systems Comdial Telephones & Systems dss/blf on executech

Hi

I am installing an executech 0616 system, and one of the phones has lights next to the memory buttons. can these be programmed as dss/blf buttons? I try itcm 85 and the dial tone starts pulsing on and off regularly. any help would be appreciated.

Thanks
[email protected]

If it's an older Executech,
1.ITCM
2.SAVE
3.Press the button you want to program
4.ITCM
5.Dial station number
Repeat 2-5 for other buttoms
Press SPKR or MONT to end

Also it will need the paired port to work right 10-11 12-13 14-15 and so on

[This message has been edited by dtmf (edited May 12, 2004).]

Hang on a sec... this is a 6614 as pictured... can you elaborate on it needing a paired port?

<img src='https://www.telbroker.com/telephones/Com6614-PG.gif'>

The 0616 can use the 3508 OOOM, 3508 O35M, 3598 OOOS,and the 6414 series. The 6614 wasn't used for the 0616. It was used on the 1432, 2232,2296 and newer systems

They made a DSS/BLf set that used both paired ports to support it, you could put up to 8 on a 0616 system.



[This message has been edited by dtmf (edited May 12, 2004).]

So on a 6414 that should work? I was just going by the pic, I will have to check the exact model of the phone

To get dss/blf on the older system you need a 6414-L,(same as the 6414 but with led's next to the upper 14 buttons) I think it was 2 per system one on the first port and the other on the last port. 6600 series will not work on that system.

I like the picture

Yes that is a nice picture isn't it

Hey just asking... did I break a rule linking to a pic from this site in a post? I was using it for reference.

No, your fine.