|
|
Joined: Mar 2006
Posts: 171
Member
|
Member
Joined: Mar 2006
Posts: 171 |
Strange problem, customer has an FXII Expansion (17E) with a PRI. System has been in place a couple years. Couple of weeks ago the customer says there are two numbers when called from a particular phone the call will be dropped. They can go to another phone and the calls to the same numbers will complete. Checked the obvious things; changed phones, checked COS, toll restriction and all OK. After more troubleshooting I found that by removing the entry in "outbound calling number ID" under station programming the call would then complete. I found that any phone that had an entry in this field would drop calls to these numbers. When I say dropped call, the dialed number showed in the display on the phone, the next step would be ring back tone but the display would revert to normal and the call was gone. I left the "outbound calling number ID" field blank and this person has had no more problems. Today, same customer, different phone. Calls a number, gets the AA for that company, is given 6 options (Digits 1 -6) but will drop the call if digit 3 is dialed. Any other digit and the call is transferred. Remove the entry in the "outbound calling number ID" field and when the digit 3 is pressed the call is transferred. Also found by changing "Calling Number ID Mode" (PRI Board Programming) to "Default Number" (was Station Number) I can eliminate the problem. OK, so the question is why does changing these parameters allow these calls to be completed? As far as I know these parameters haven't changed since installation and now these problems arise. Any ideas?
|
|
|
Visit Atcom to get started with your new business VoIP phone system ASAP
Turn up is quick, painless, and can often be done same day.
Let us show you how to do VoIP right, resulting in crystal clear call quality and easy-to-use features that make everyone happy!
Proudly serving Canada from coast to coast.
|
|
|
Joined: Jun 2005
Posts: 24
Member
|
Member
Joined: Jun 2005
Posts: 24 |
There is a known issue with 17e 197. Look on the ccc to find the faq. You are going to have to upgrade. I've been having the same problem with ARS over a VoIP network because of this.
|
|
|
|
Joined: Mar 2006
Posts: 171
Member
|
Member
Joined: Mar 2006
Posts: 171 |
I looked at ccc, but couldn't find the faq you are referring to. What is it under?
|
|
|
|
Joined: Jun 2004
Posts: 4,552 Likes: 5
Moderator-Comdial, ESI, Voicemail, Cisco
|
Moderator-Comdial, ESI, Voicemail, Cisco
Joined: Jun 2004
Posts: 4,552 Likes: 5 |
Look under software release notes, for release 198. In that bulletin, look for "Incorrect outgoing call information on hub’s PRI line (CR 14405)". It looks like that's what Darman951 was referring to.
|
|
|
Forums84
Topics94,512
Posts639,934
Members49,844
|
Most Online5,661 May 23rd, 2018
|
|
|
|
|