atcomsystems.ca/forum Forums TDM Business Telephone Systems Samsung Telephones & Systems OS500 SVMi-8 auto login

I have set "Auto Login:Y" in the Extension block,
but when I press VMMSG key I hear "MailBox 2xxx, record ..."

How to make MailBox play messages after pressing VMMSG key without any login and passwords ?

It sounds more like a pointer is not correct.
Is the direct station, forward station set up correctly.

What exactly does it say?

Just remove the passwod in the "Personal Administration" for the mailbox.

If you want to do it system wide just change it in the system wide parameters. This probably won't work for existing subscribers but it should work for all new mailboxes created later.

More detail

In Day Mode I have assigned MailBox Menu to the DS.
Then in this menu INPUT processor take CID (ext#) and search corresponding MailBox (MBX).

"What exactly does it say?"
Mailbox 2008. Recording.

"Just remove the passwod in the "Personal Administration" for the mailbox."

I have deleted Subscriber Default password and Subscriber admin p/w in the System Wide Parameters and Extension with MailBox. Then I have rovered Ext and Mbx. Now after pressing VMMSG key I must press # only without p/w.

Is this an SVMIE or just SVMI? Not sure why you would have to press #. I just reset a couple of extensions here in the office and they go straight to the messages when the vmmsg key is pressed

"Is this an SVMIE or just SVMI?"

VoiceMail Card has label SVMi-8, LAN and SIO ports.
There is "SVMi-8 Release R3.0" in the System Wide Parameters.

I suppose that is SVMi-8E card.

"I just reset a couple of extensions here in the office and they go straight to the messages when the vmmsg key is pressed"

I am reseted my extension, but nevertheless I must press # to hear new messages

OK. I reseted SVMi to default state. Now all works perfectly. For auto login it is quite enough to setup
Auto Login flag in the Extension Block!

I have found that in the default Day Mode "Direct station MNU" assigned to DS Call Code. But this menu isn't present in the Menu Block Table.

I guess that MVMSG key routed to Menu for tanslation CID and routing to the self MailBox.

How to program Menu, Extension, MailBox, EClass and MClass Blocks for the activation Auto Login ?