atcomsystems.ca/forum Forums TDM Business Telephone Systems Samsung Telephones & Systems Vlans

Here Here, well at least retired, maybe not dead

Maybe my IT support background helps, but VLAN's for seperating VoIP and normal data arn't that hard to setup.
Maybe netgear make it hard, but on the cisco's (and the GPLIM/GSIM's since the program on them was written by ex cisco engineers) its fairly easy.

But I don't see the need for a fully ip system, other then it makes phone relocation easier (just unplug your phone and plug it in at your new desk)

OK, Ive setup the vlan now.
FYI on Cisco 3500 XL switches I had to set al ports as trunk ports with 802.1Q encapsulation.
I have 3 lans 100 for phones, 110 for data and 120 for management. The default COS on the ports is 0

Once I had updated all phones to be on a suitabl firmware vesion I configured them as follows:

LAN Port 1 100 7 = Enabed On Vlan 100 with COS of 7

PC Port 1 1 1 = Enabled on VLAN 110 with COS of 1

I have set the port the OfficeServ Pluggs into as an access port on VLAN 100 so it only allows traffic from VLAN 100 to pass through.

The voice mil system (which uses our data network t email messages) has been plugged ino an access port on the switch on VLAN 110.

No reportasyet (touch wood) of and clarity problems.

We have however had 1 instance of a page problem. This occurs whn a user tries a page. They press ** to page all users (including a tannoy system) the beeps start but do not finish and the user cannot page. Has anyone seen this error before?

Sorry that should have read

PC Port 1 110 1 = Enabled on VLAN 110 with COS of 1

What MGI card are you using and how many members are in your page group? Do you have the MGI card set to USE under Remote MGI in programming?

I ran into this problem and I had more members in the page group than MGI channels. Reducing the number of members corrected the problem. I don't know if this is your problem, but it's a good place to start.