|
|
Joined: Nov 2004
Posts: 6
Member
|
OP
Member
Joined: Nov 2004
Posts: 6 |
I have an ids 42 which I can not get to go into program mode. It was mothballed for over two years. I can get my wyse 50 emulation to connect, but no other software.
u41 and u42 chips are labeled as 8.0.1
|
|
|
|
|
Joined: Sep 2001
Posts: 2,290 Likes: 5
Moderator-Executone-Isoetec, Samsung
|
|
Moderator-Executone-Isoetec, Samsung
Joined: Sep 2001
Posts: 2,290 Likes: 5 |
What are you getting an operator screen?If that's what you have then press Ctrl-P to access the programming mode.This may be defaulted to the serial port being an operator screen.This can be changed on the B screen under operator where the operator is assigned a port.Just go to that and remove itby pressing N I think and it will become a programming port.
|
|
|
|
|
Joined: Nov 2004
Posts: 6
Member
|
|
OP
Member
Joined: Nov 2004
Posts: 6 |
Thanks, You were correct. I jumped in to the programming screen no problem.
Thanks again..
|
|
|
|
Forums84
Topics93,884
Posts637,026
Members49,675
| |
Most Online5,661
May 23rd, 2018
|
|
|
|
