sundance-communications.com/forum Forums Other TDM Phone Systems Executone-Isoetec Telephones & Systems Aquired IDS 108

I just aquired a IDS 108 system with MDF panels, a I/O panel and the modified Wyse terminal. I am not familiar with executone systems at all but have experience with several other PBX's. I'm not sure where the operators terminal is supposed to connect to the system, or how it all connects together with the ISOTEC grey box that goes along with it. Any help or manuals if someone has them would be useful. Thanks in advance.

The CRT is connected to the I/O panel in ports 3 or 4. The 'gray box' is the operator's integration base. You would use this when using the CRT as an operator's position. The base isn't required if all you're using the CRT for is programming.

Manuals can be found at https://www.quick-manuals.com/

------------------
www.mainresource.com

I am frankly suprised that quick manuals has not received a pleasant "cease and desist" from the legal department at InterTel. Intertel will only allow their manuals to be sold on CD through liscensed providers. They will not allow manual downloads. We have the manuals on CD.
System programming on the IDS can also be done using a PC and Procom Plus.

------------------
Executone/Isoetec Manuals
Toshiba Telephone Repair
P.S. Hi Joe!
[This message has been edited by paul144 (edited January 12, 2005).]

[This message has been edited by paul144 (edited January 12, 2005).]

I have manuals. and can help you with the installation for a small fee

Thanks for all the help guys. I was successful in wiring up the system, resetting it to defaults and testing the phones/CO lines. I verified function so off to be sold it goes.

Thanks Again,
USMCinDC