|
|
|
|
Joined: Sep 2008
Posts: 2
Member
|
|
Member
Joined: Sep 2008
Posts: 2 |
I'm adding PRI to an APS SW ver 7.01. I can receive calls but when I try to dial out the channel drops. All dipswitches on DTI-P are off, Adtran T1 CSU ACE is installed, Channels are set as active in class 29 group 1, system was defaulted with card installed in slot 1 of the base cabinet. How can I tell if the card has been flashed for something else?
|
|
|
Visit Atcom to get started with your new business VoIP phone system ASAP
Turn up is quick, painless, and can often be done same day.
Let us show you how to do VoIP right, resulting in crystal clear call quality and easy-to-use features that make everyone happy!
Proudly serving Canada from coast to coast.
|
|
|
|
Joined: Aug 2006
Posts: 1,811 Likes: 15
Moderator-Iwatsu
|
|
Moderator-Iwatsu
Joined: Aug 2006
Posts: 1,811 Likes: 15 |
Check with the PRI provider as to which protocol is being used, NI, 5ESS or DMS-100. Make sure all the trunks match that protocol for starters.
Make sure in configuration that a D channel has been allocated.
Make sure the group attribute is set to 2 way in Class 29.1 and that the lines are set to DP in Class 11.08 for each trunk.
Hope this helps.
Sometimes the thoughts in my head get so bored, they go for a stroll through my mouth. This is rarely a good thing.
|
|
|
|
|
Joined: Sep 2008
Posts: 19
Member
|
|
Member
Joined: Sep 2008
Posts: 19 |
Also, in class 29, check to make sure the channels are assigned into trunk group 1 in the logical trunk bit map.
|
|
|
|
Forums84
Topics94,515
Posts639,966
Members49,848
| |
Most Online5,661
May 23rd, 2018
|
|
|
|
|
|
