Phone Systems

Previous Thread
Next Thread
Print Thread
Rate Thread
Page 1 of 2 1 2
#486013 11/15/08 07:04 AM
Joined: Jun 2007
Posts: 60
ugly1 Offline OP
Member
OP Offline
Member
Joined: Jun 2007
Posts: 60
I was wondering if any of the oldtimers here installed the pre-amphenol 565h sets?The BSP shows four or five 44a blocks were required.It seems that between mounting the backboard and 44a blocks,stripping and terminating the inside wiring cable,and then terminating the spade tips of the d42a cord,it must have taken almost an hour to install one set.And I imagine that installing a 465 series set was worse.

Advertising Sponsor
#486014 11/15/08 07:21 AM
Joined: May 2007
Posts: 5,005
Likes: 2
Moderator-1A2, Cabling
*****
Offline
Moderator-1A2, Cabling
*****
Joined: May 2007
Posts: 5,005
Likes: 2
An hour sounds about right. I never installed them. I disco'd quite a few that NY Tel left behind that were in the way of our installations.

We had one job once, way out on Suffolk County that was in an old mansion. The company I worked for then (1977) had bought the existing cable plant from NY Tel and I was given the job to install a 1A2 system.

"What could be easier?" I was told. "It's a cable buy."

The cable was old color code mounted on all 44a blocks. It would have been faster to rerun the job, except the cable wouldn't have been hidden. I had to figure out the color code, make up amphenol tails to wire to the blocks at the station end and then make up more tails at the head end to the KSU. Of course they hadn't used 25 pair either (I don't remember what the cable count was, but I remember that had to be creative with A1 leads and lamp grounds).

A job and a half.

Sam


"Where are we going and why are we in this hand basket?"
#486015 11/15/08 07:53 AM
Joined: Dec 2002
Posts: 9,409
Likes: 1
Member
*****
Online Content
Member
*****
Joined: Dec 2002
Posts: 9,409
Likes: 1
What is a 44a block?


Jeff Moss

Moss Communications
Computer Repair-Networking-Cabling
MBSWWYPBX, JGAE
#486016 11/15/08 08:27 AM
Joined: Jun 2006
Posts: 8,712
Likes: 1
Moderator-Nortel, Computers, General
*****
Online Content
Moderator-Nortel, Computers, General
*****
Joined: Jun 2006
Posts: 8,712
Likes: 1
It's just a connecting block for 5 pairs if I remember right.


Scientists say that the universe is made up of Protons, Neutron & Electrons. They forgot "Morons".
Dave. (CTUB) Canadian Techs Use Bix!
#486017 11/15/08 09:58 AM
Joined: Jan 2005
Posts: 15,290
Likes: 3
Moderator-Vertical, Vodavi, 1A2, Outside Wire
*****
Offline
Moderator-Vertical, Vodavi, 1A2, Outside Wire
*****
Joined: Jan 2005
Posts: 15,290
Likes: 3
Jeff;

Dave is right on. A 44A block is a five pair screw-terminal block, very similar to a 42A block but larger. Backboards were available to permit them to be stacked with one common cover. These were used for multi-line phones with spade-tipped terminals on the line cords before 25 pair connectors came along.


Ed Vaughn, MBSWWYPBX
#486018 11/15/08 12:08 PM
Joined: Sep 2006
Posts: 3,290
Member
*****
Offline
Member
*****
Joined: Sep 2006
Posts: 3,290
[img]https://www.phonecoinc.com/topic.as...up=misc&category=Acc&topic=01056[/img]

https://www.phonecoinc.com/topic.as...up=misc&category=Acc&topic=01056

The photo is a 44A block with the cover on. Underneath are 10 screws and channels to guide the I/W leads and cord conductors.

I converted lots of 1A system 464 and 564 sets using the original color code to the new sets with amphenols, using the even count code. The T, R, B & H leads were in order, but the lamps used the yellow group. The first line lamp used Bl/Y, the second used Or/Y, etc.


Arthur P. Bloom
"30 years of faithful service...15 years on hold"

#486019 11/15/08 04:44 PM
Joined: Oct 2004
Posts: 374
Member
Offline
Member
Joined: Oct 2004
Posts: 374
[Linked Image from i228.photobucket.com]

This is a pic of the tie down on 4 44A blocks which were mounted on a wooden backboard. The 44A block were roughly this shape. The cable was tied down and then spade tips from the cord from the set was then tied down on the block. In the beginning maybe 2 cables plus the set would be tied down on each screw putting multiple sets on a single run. Single 44A blocks were used on AE 87 sets and on AE 187 sets until amphenol ended cords came out.

#486020 11/18/08 05:17 PM
Joined: Dec 2007
Posts: 908
Member
Offline
Member
Joined: Dec 2007
Posts: 908
Oh the memories, when i worked for PT&T we did the new addition to the SOCAL GAS CO.

#486021 11/18/08 05:23 PM
Joined: Dec 2007
Posts: 908
Member
Offline
Member
Joined: Dec 2007
Posts: 908
it was tough doing those on the floor screwed to your installers grip, so I had the boss get 2 splicers stools mounted a long backboard at an angle, loaded the little bins with blocks,covers, and the 44a back boards. Now we could sit down do up a block, (less than an hour) slide over to the next location and do it all over again.a real time saver and of course no acknowledgement.

#486022 11/18/08 07:29 PM
Joined: Jan 2005
Posts: 15,290
Likes: 3
Moderator-Vertical, Vodavi, 1A2, Outside Wire
*****
Offline
Moderator-Vertical, Vodavi, 1A2, Outside Wire
*****
Joined: Jan 2005
Posts: 15,290
Likes: 3
But look at the bright side, Jim....You can still walk upright. I can't even imagine doing those things the hard way. Even a 66E3 block pushes my knees to the limit.


Ed Vaughn, MBSWWYPBX
Page 1 of 2 1 2

Moderated by  ChrisRR, EV607797, Silversam 

Link Copied to Clipboard
Most Recent 5 Post
Saying good by to all the rest of my toshiba
by SSPhone - 05/07/21 04:28 PM
IP Office 500 V2 crash
by Mercenary Roadie - 05/07/21 08:24 AM
Random characters on screen
by dougster - 05/06/21 06:49 PM
How to subscribe to get full access.
by Ruben - 05/05/21 09:29 PM
OS UNI Card Version Question
by RM SYSTEMS - 05/04/21 04:53 PM
Popular Topics (Views)
Forum Statistics
Forums93
Topics94,377
Posts639,660
Members49,454
Most Online5,661
May 23rd, 2018
Today's Birthdays
KWH, PulseDial
Newest Members
Andrea Sau, eos90066, Sonic, ERA, Mackino
49,454 Registered Users
Get Tech Support Now! Click the banner below
Get Tech Support Now!
defencebyte.com
Antiransomware
Global Test Supply
EMP & Lightning Home Surge Protection
EMP - Click Here!
Top Posters (30 Days)
dexman 48
pvj 18
Ruben 15
bditech 11
Phone.com 300x250
300x250 Your Business Phone Service in the Cloud
www.aweber.com
landing page builder
Linked Banner to your Product or Website
NordVPN
Advertising Sponsor Spot 2
EMP Shield for Commercial - Home & Vehicle
Use Coupon code SAVE - Click Here!
Who's Online Now
33 members (sundance, dexman, hbiss, nameless, nortelvoip, Yoda, mbhydro, nfcphoneman, newtecky, BobRobert, pvj, Mercenary Roadie, CyberLaw, jeffmoss26, JBean3329, Touch Tone Tommy, Curlycord, Bushmills, Carl Navarro, Professor Shadow, SSPhone, KRRath, Ruben, justbill, gelehu, dougster, Biztel Cuban Okie Tech, hitechcomm, mongo5150, www.telcom1.net, Skunky, MooreTel, metelcom), 459 guests, and 85 robots.
Key: Admin, Global Mod, Mod
vpnproxymaster
Contact Us | Telephone System Tech Support | Terms of Service

Sundance Communications is not affiliated with any of the above manufacturers.
©Copyright Sundance Communications 1998-2021
Trusted Partners