sundance-communications.com/forum Forums TDM Business Telephone Systems NEC Telephones & Systems Swapping out SLI(8)-u10

Aloha,

I am VERY new to this NEC IPK phone system and have only worked with Cisco VoIP and Intertel Axxess systems in the past.

I have an analog line that had no dial tone, plenty of static. Had a phone guy (not the vendor who sold the company this system) come out and troubleshoot. He came to the conclusion that it was a bad SLI card. I ordered a new SLI card, put it in today and the static on the line is gone, but no dial tone.

I rebooted the switch to no avail. I am wondering there are any other steps I am supposed to take when swapping a card like this.

Any assistance is greatly appreciated!

Sounds like that particular port is either not programmed in 4-10 with an extension number or there is a cabling issue.

Make sure the amphenol cable on the side of the KSU is snapped all the way in.

D

Thank you for the reply. Phone guy came out and showed me the blown capacitor on the "new" card. Another one being shipped over.

As an aside, I downloaded the programming manual for this particular system. Kudos to those of you who have mastered this kind of stuff. Makes Call Manager and Cisco router/switch configs look like kids play. I prefer kids play

Aloha!