|
|
|
|
Joined: Mar 2007
Posts: 29
Member
|
|
Member
Joined: Mar 2007
Posts: 29 |
I lost the display on the console (302C) Console is on a TN 754B two pair dig. card. I tested power supply. Even went so far as removing adaptor and wired it direct to pins 7&8 of jack right at console location. Tested it with meter on mod end before it goes into console and have -50 volts right on plug going into console. I've reset console, busyed and released port. Still no display. Just wanted to make sure I haven't missed something before i shell out $400.00 for a refurbed one.
Can I use a 302B with that same card? Could save a little money if I can use a B.. Thanks
|
|
|
|
|
Joined: Sep 2006
Posts: 204
Member
|
|
Member
Joined: Sep 2006
Posts: 204 |
Sounds like you have covered pretty much everything other that taking the console apart and checking that the ribbon cable has not come loose. If memory serves me you can use a 302B on that circuit pack. We changed to the 302D's a long time ago.
|
|
|
|
|
Joined: Sep 2005
Posts: 898
RIP Moderator-General
|
|
RIP Moderator-General
Joined: Sep 2005
Posts: 898 |
Yep...sounds like the display is shot...and yes you can switch it to a 302B with no problem since your using the 754..save yourself a few $$$.
...bob...
Bob Wells
WellComm, Inc.
"As long as nobody's dead or in jail, it can't be all that bad ! "
|
|
|
|
|
Joined: Mar 2007
Posts: 29
Member
|
|
Member
Joined: Mar 2007
Posts: 29 |
Thanks guys..... Ordered a replacement this a.m.
|
|
|
|
Forums84
Topics94,491
Posts639,864
Members49,836
| |
Most Online5,661
May 23rd, 2018
|
|
|
2 members (justbill, SeyerIT),
248
guests, and
337
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
|
|
|
