Comdial DX-80 no loop current

Print Thread

Rate Thread

Comdial DX-80 no loop current #595614 11/30/15 02:34 PM
Joined: Nov 2015 Posts: 1 USA JacobAllen Member
JacobAllen Member Joined: Nov 2015 Posts: 1 USA	Hello, I have a Comdial DX-80 and have 3 lines hooked up to it. When we came in this morning lines 1 and 2 were not working and say "No Loop Current" when you try and access them. When I call lines 1 or 2 from an outside line they roll over and line 3 rings. I tried power cycling the phone system a couple of times but there has been no change. The LED is blinks ready steadily. Any help is appreciated. Thanks, Jacob

Atcom VoIP Phones

Best VoIP Phones Canada

Visit Atcom to get started with your new business VoIP phone system ASAP
Turn up is quick, painless, and can often be done same day.
Let us show you how to do VoIP right, resulting in crystal clear call quality and easy-to-use features that make everyone happy!
Proudly serving Canada from coast to coast.

Re: Comdial DX-80 no loop current JacobAllen #595625 11/30/15 07:14 PM
Joined: Aug 2004 Posts: 9,172 Likes: 22 Eastern North Carolina RATHER BE FISHING Admin
RATHER BE FISHING Admin Joined: Aug 2004 Posts: 9,172 Likes: 22 Eastern North Carolina	You have lost the system ability to see dial tone on Line 1 and 2...hence the no loop current. Either the lines are bad, disconnected, or the CO port in the KSU has been blown. You'll need a test set to figure out which issue you have.

Moderated by 5years&counting, jwooten, RATHER BE FISHING

Hop To

Link Copied to Clipboard

sundance-communications.com/forum Forums TDM Business Telephone Systems Comdial Telephones & Systems Comdial DX-80 no loop current