|
|
Joined: Sep 2005
Posts: 9,289 Likes: 15
Admin
|
Admin
Joined: Sep 2005
Posts: 9,289 Likes: 15 |
It's hard to believe that RF may be the cause of this but still possible. Even though the horns are plastic it is possible that they have some shielding around the amp. It also possible that there is a cap or resistor difference in the amplifiers that could make one react to a RF frequency while the other works fine. If a ceiling speaker and horn have both the audio and power connected in parallel and it only effects the speaker then that eliminates many components. Have you tried to shield the ceiling speaker amp?
|
|
|
Visit Atcom to get started with your new business VoIP phone system ASAP
Turn up is quick, painless, and can often be done same day.
Let us show you how to do VoIP right, resulting in crystal clear call quality and easy-to-use features that make everyone happy!
Proudly serving Canada from coast to coast.
|
|
|
Joined: Feb 2005
Posts: 12,354 Likes: 4
Member
|
Member
Joined: Feb 2005
Posts: 12,354 Likes: 4 |
If I understand correctly the noise affects all the ceiling speakers not just one. The only practical way to shield these speakers is to install them in a back can connected to a proper ground. If it were me and it came down to that I would rather rip it all out and do it the right way. Self powered speakers all over the place with power and line level audio wiring (especially home run from each speaker) is not the way to go. You're only asking for trouble.
-Hal
CALIFORNIA PROPOSITION 65 WARNING: Some comments made by me are known to the State of California to cause irreversible brain damage and serious mental disorders leading to confinement.
|
|
|
|
Joined: Oct 2010
Posts: 250
Member
|
Member
Joined: Oct 2010
Posts: 250 |
Suga Ray Jay,
Just wanted to know if you tracked down the source of the problem and corrected it ?
Thanks,
Forty six years and still fascinated with Telecommunications!
|
|
|
|
Joined: May 2012
Posts: 20
Member
|
Member
Joined: May 2012
Posts: 20 |
Have not found the problem yet. This issue is more or less on the back burner now. I am looking into replacing the ceiling speakers though.
Jason
|
|
|
|
Joined: Jul 2012
Posts: 6
Member
|
Member
Joined: Jul 2012
Posts: 6 |
I'm pulling my hair out with a somewhat similar problem... all my ceiling speakers have a low hum on them while they are idle, but none of the horns (using same power supplies) have any hum on them. I'm stumped.
|
|
|
|
Joined: Jan 2013
Posts: 522 Likes: 1
Member
|
Member
Joined: Jan 2013
Posts: 522 Likes: 1 |
This thread is from 2012. Try starting a new one
Patrick T. Caezza Santa Paula, CA 93060 C-7 - Low Voltage System Contractor - Lic# 992448
|
|
|
Forums84
Topics94,512
Posts639,934
Members49,844
|
Most Online5,661 May 23rd, 2018
|
|
0 members (),
149
guests, and
35
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
|
|