sundance-communications.com Forums Telephony Discussion Phone & VoIP Systems Nortel Telephones & Systems Hold on Call 1

I have a Norstar user that when she presses her HOLD button to put a call on HOLD, the display will show Hold on Call 1. Her icm will not flash.
She can not get the call back. When the call recalls back, it says Park Recall

How do I change it to normal HOLD.

Normally if you put a call on hold it wouldn't say anything, line 1 would flash or intercom key would flash.
If a call is parked it would NOT flash.

The hold key appears to be parking calls rather than putting them on hold.

This is either some vintage software or the client is using the wrong button.
Hold key is fixed and is Red
Park key is programmable to the other keys.

Wait for others to give some input.

Have her show you how they put it on hold...

She pt the call on Hold as normal using the Hold key.
Girl next to her does the same operation, and it goes on hold as normal.
I going to change out the phone, and see what happens

If changing the phone works, then clean the rubber membrane inside and it should be good to go.

Maybe a sticky "Park" key? see if they have one programmed too.

See if you have software that has swca call hold keys feat 73 on and off on phones that do not have mult call keys.
Jim

Swaped phone, no difference.
And wouldnt you know its the owner's daughters phone

Give her a different extension port and reprogram her phone appropriately...

Copy the data from another port known to be working & then edit as required (name, ringing options etc). Something is corrupted.