Business Phone Systems

Previous Thread
Next Thread
Print Thread
Rate Thread
#619538 05/05/18 03:13 PM
Joined: Aug 2014
Posts: 26
Member
OP Offline
Member
Joined: Aug 2014
Posts: 26
Customer has a Vodavi XTSc-IP KSU with the V86 MBU. Extension 100 show NO SYNC. The KSU has several boards added. None of the LEDs on the various add on boards light up.

There are 3 LEDs located by the PMU board (a daughter-board the mounts to the MBU). They are also close to the battery.
1. When I power up on the mains (AC) the bottom LED (LD1) comes on faintly and LD2 and LD3 are both not illuminated.
2. When I jumper 24 V DC into the backup power supply input the bottom one (LD1) burns brightly, LD2 burns faintly, and LD3 doesn't illuminate.

I am thinking bad power supply capacitors but am looking for advice. The non-volatile memory battery (1/2 AA lithium) is dead, which I will replace.

Any ideas if which capacitors would be the culprit? Or any other test I should run?

Atcom VoIP Demo
VoIP Demo
aeronautical #619584 05/06/18 08:36 PM
Joined: Aug 2003
Posts: 5,148
Moderator-Vertical, Vodavi
*****
Offline
Moderator-Vertical, Vodavi
*****
Joined: Aug 2003
Posts: 5,148
Most likely it's the capacitors. See this thread: https://sundance-communications.com/forum/ubbthreads.php/topics/535196/1

Look for a post by a user named "toogood". He tells you which capacitors are the common culprit.

aeronautical #619594 05/07/18 01:28 PM
Joined: Aug 2014
Posts: 26
Member
OP Offline
Member
Joined: Aug 2014
Posts: 26
That one is bulging!!! I will replace it and maybe the rest of those four while I am at it.

Thank You

aeronautical #619658 05/09/18 12:51 AM
Joined: Jan 2008
Posts: 3,821
Retired Moderator
****
Offline
Retired Moderator
****
Joined: Jan 2008
Posts: 3,821
The too small cap problem, ugly. I had so many XTSc's fail it was almost criminal.


www.myrandomviews
"Old phone guys never die, they just get locked in some closet with an old phone system and forgotten about"

Retired, taking photographs and hoping to fly one of my many kites.
aeronautical #619822 05/12/18 10:50 PM
Joined: Aug 2014
Posts: 26
Member
OP Offline
Member
Joined: Aug 2014
Posts: 26
Anybody know what the value of R-349 is? This one is burned, so I can't read the bands. It does test at 218 ohms but as you know, heat can change that.

aeronautical #619823 05/12/18 11:48 PM
Joined: Feb 2005
Posts: 12,334
Likes: 3
Member
***
Offline
Member
***
Joined: Feb 2005
Posts: 12,334
Likes: 3
Resistor.

-Hal


CALIFORNIA PROPOSITION 65 WARNING: Some comments made by me are known to the State of California to cause irreversible brain damage and serious mental disorders leading to confinement.
aeronautical #619841 05/13/18 05:11 PM
Joined: Aug 2014
Posts: 26
Member
OP Offline
Member
Joined: Aug 2014
Posts: 26
Yes, it is a resistor. But the value isn't silk screened under it and this one is burned a bit in the middle. First band is red (2), second band is violet (7), can't read the next one or two bands to determine if there is a third digit or just the multiplier which I can't read either, tolerance band is gold (5%),

It tests at 217.7 so it is already out of tolerance since the second band is violet.

Does anyone know what the prescribed value of it is?

aeronautical #619895 05/15/18 04:23 PM
Joined: Aug 2014
Posts: 26
Member
OP Offline
Member
Joined: Aug 2014
Posts: 26
Does anyone know where I can get a schematic of the MBU? I could get the value of this resistor from that.

Failing that, does anyone know where these boards are rebuilt since Vodavi was acquired by Vertical and now Veritcal has been acquired by somebody else?

IS there any support for these still in existence???


Moderated by  EV607797, JWRacedog, MnDave, nfcphoneman 

Link Copied to Clipboard
Forum Statistics
Forums84
Topics93,832
Posts636,788
Members49,649
Most Online5,661
May 23rd, 2018
Popular Topics(Views)
Today's Birthdays
AWhite, jnimmick, MarkTPN
Newest Members
Lazlo, devben, bubblegum, Carl Arnold, Marjan Shaw
49,649 Registered Users
Top Posters(30 Days)
ramo 13
pvj 11
Toner 9
dans 5
Who's Online Now
0 members (), 20 guests, and 33 robots.
Key: Admin, Global Mod, Mod
Contact Us | Sponsored by Atcom: Business Phone Systems | Terms of Service

Sundance Communications is not affiliated with any of the above manufacturers.
©Copyright Sundance Communications 1998-2023
Powered by UBB.threads™ PHP Forum Software 7.7.5