sundance-communications.com/forum Forums TDM Business Telephone Systems Nortel Telephones & Systems BCM-400 3.7 - Voice Mail Services

One more thing.
Have one ASM module - worked OK in BCM-400 3.6.
Now it is in BCM-450 R6.
All it does is flash - will not come ready.

Dip switches are set.
Resources say ENABLING but never goes Enabled.
Ports say Unequipped.

Any thoughts on this one?
Thanks

CAP
Try going to CAP Assignment and add the DN

ASM
Wait up to a full 15 minutes for it to come up.
or if you have done so already:
From Phone only!
Go and disable the MBM in Maintenance
Go to Hardware and select ASM or something else then back again.
Go back to Maintenance and renable MBM

There is a couple other things to try but what NT number is it?

I was wondering if the R6 would not let the CAP be a DSS only.
Will have to try to prog as a CAP.

ASM:
It has had hours to come up and still not yet.
But I did not think of access via the phone.
That might just work.
Will try it.

Did not pay attention of the NT number - will check it if I remember.

THANKS.