sundance-communications.com/forum Forums TDM Business Telephone Systems Avaya - Lucent Telephones & Systems Legend DID Digits Table?

How/where does one set up an incoming DID Digits table for a T1? I searched through the manual and don't see it anywhere. I am new to Legend, but not T1. I am used to seeing a master "Table" where you put the incoming digits : ring to extension X. There doesn't seem to be anything like that on a Legend.

Is the Legend one of those phone systems that you simply set the extension number equal to the expected incoming digits and your done?

Hammer

"Is the Legend one of those phone systems that you simply set the extension number equal to the expected incoming digits and your done?"

Yup.

Unless the T-1 is a PRI. Then you can change/map digits to any extension.

Thanks. Off topic- What are the main differences between the Legend and the Magix?

Hammer

7.0 was the last Legend. Magix supports the new 44XX series phone with TDL cards. Any Legend can be upgraded to Magix if it has a CKE4 or CKE5 processor. Magix changed to a metal carrier. A 100R INA board was added and only can be used with Magix. Magix stopped supporting older 400, ATL and BRI boards.