sundance-communications.com Forums Telephony Discussion Phone & VoIP Systems Avaya - Lucent Telephones & Systems Changing DSS Options

I have a system that was set up years ago by lucent and the support is long gone. We finally have a need for a DSS off the main operator phone (a 20L).

I have the DSS hooked up but upon inspection of the page buttons they are set to:

Page1: 4000
Page2: 6000
Page3: 6050

However our extensions range from 3740 through 3799.

I have spent an hour digging through the legend programming through SPM and have failed to find the area where I can change these options.

If anyone can guide me in the right direction I would greatly appreciate it.

My hope is I can make page1: 3740 but based on what I see I may be out of luck and have to make it 3700 and have the first 40 buttons do nothing

Thanks in advance

Matthew Fisk


[This message has been edited by MAFisk (edited November 29, 2004).]

I finally tracked down a manual on the internet.

SysRenumber-->Single-->MORE-->DSS Buttons

Just posting it here in case others end up needing to figure this out.

Alas as I suspected since our extensions start at 3740 that means Page1 of my DSS essentially has 40 unused buttons.

M

[This message has been edited by MAFisk (edited November 29, 2004).]

[This message has been edited by MAFisk (edited November 29, 2004).]