sundance-communications.com/forum Forums TDM Business Telephone Systems Avaya - Lucent Telephones & Systems Avaya merlin magix & legend T1 Configuration

Does anyone out there have a instruction on setup a PRI T1 on a merlin magix or legend.

Thanks,

From your web site:
WILLMAX TELECOM IS PROUD TO BE FLORIDA'S NUMBER ONE AUTHORIZED DEALER IN BOTH SALES & SERVICE FOR AVAYA, NORTEL,PANASONIC, SAMSUNG, TOSHIBA AND NEC TELECOMMUNICATIONS PRODUCTS . INCLUDING VOICE MAIL AND WIRING

and your asking the question you ask in here?

How can you be an Authorized dealer of these products and ask questions like your asking?
Your susposta know this stuff.

Well,apparently you are an installer that doesnt know this. AND I am not worthy of being an installer, but here ya go anyway.....


Switch must be on Hybrid Mode

1. Set Frame Format to Extended Super Frame
Lines Trunks=>LS/GS/DS1=>enter slot + Enter =>Frame Format=>Extended Super Frame=>Enter.

2. Set Suppression
Lines Trunks=>LS/GS/DS1=>enter slot + Enter =>Suppression=>B8ZS=>Enter.

3. Change Type to PRI.
Lines Trunks=>LS/GS/DS1=>enter slot + Enter =>Type=>PRI=>Enter.

PRI MENU

4. Set Switch Type.
Lines Trunks=>PRI=>Switch Type=>make choice+Enter.

5. Program B-Channel Group.
B-Channel Group=>B-Channel=>When prompted for b-channel group, type 1+ Enter.
When prompted for B-Channels, enter in the form: slot/B-Channel(sspp)
starting with B-Channel 23 and working down to B-Channel 1. Example: if slot is 4,
type 0423, enter, 0422, enter, 0421, enter, ect……….0401.
Return to B-Channel Group menu.

6. Program Lines.
Lines=> when prompted for b-channel group, type 1 + Enter=>enter line trunks (1st 23 only).
Return to B-Channel Group menu.

7. Set Network Service.
Ntwk Svc=>Misc=>CallByCall=>Enter.
Return to B-Channel Group menu.

8. Set Incoming Routing.
Incoming Rtg=>Dial Plan=>Enter.
Return to B-Channel Group menu.

Back

9. Program Dial Plan Routing.
Dial PlanRouting=>Service=>0=>Misc=>Any=>Enter.
Exit back through Dial Plan Rtg menu to PRI menu.

Back

10. Program Outgoing Table.
Outgoing Table=>CBC Svc=>Pattern=>when prompted for list and entry numbers, enter 00=>Enter.
When prompted for pattern number, enter: 0=>Next(F9)=>1=>Next=>2=>Next……..8=>Next=>9=>Enter.

Back

11. Set Network Service.
Ntwk Svc=>Misc=>No=>Enter.

If this is a general use PRI, you must change the Special Service Table as follows:
PRI=>Outgoing Table=>Special Svc=>Del Digit=>When prompted for entry number, enter 0 + Enter.
Change entry to 0=>Next=>change entry to 0=>Next, ect until all entrys, 0-7 are 0.

If this is a strictly long-distance PRI, leave the Del Digit values at default.

INFO for PRI Provider

- PRI ESF B8ZS
- The Terminal Equipment Identifier (TEI) = 0
- Switch Type: 5ESS
- Optioned for "Custom"

If switch type is DMS-100, The protocol MUST be set for “NTNAPRI”. Additionally, if the switch type is DMS-100, the field “L1 flags” in the “Trunk Sub Group” table should be set to yes. This is more critical when using DS1
cards with an Apparatus code beginning with “517M”. These particular DS1 boards WILL NOT work properly without this parameter set.

Thank you so much.